Start the NetBackup Administration Console. (see relevant doc) In the menu tree on the left-hand side of the NetBackup Administration Console, the Activity Monitor will appear, with the Jobs tab showing. The following information is provided: Job ID: Identifier that NetBackup assigns to each job Type: Backup, Archive, or Restore State: Queued - Jobs that are in the NetBackup scheduler queue Active - Currently active jobs Re-Queued - Jobs that are back in the NetBackup scheduler queue because the previous attempt was unsuccessful Done - Completed jobs (whether successful or not) Status: The status code of the job (consult this status code when troubleshooting) Policy: The backup policy for this job Schedule: The schedule for this job Client: The client computer for this job Media Server: The media server for this job (polaris) Start Time: The start time for this job Elapsed Time: The elapsed time for this job End Time: The end time for this job Storage Unit: Which tape drive is being used for this job Attempt: The current attempt number for this job Operation: For active jobs, indicates the current operation (mounting, writing, etc.) Kilobytes: The number of kilobytes that have been written Files: The number of files that have been written A Status Code of 0 means a successfully completed job with no errors. A Status Code of 1 means that some files were not backed up, but the backup process continued and completed. Typically this is not a problem, as this typically means that a system file was in use when the backup was occurring, but do check the list of files that were not backed up to confirm this. To get the list of files, run a report on Status of Backups during the appopriate time period (see Reports). On any other status code, the backup did not complete successfully. Consult the VERITAS NetBackup 4.5 Troubleshooting Guide, Chapter 4 - NetBackup Status Codes and Messages to find the type of error and the recommended course of action. (remember to include how to cancel jobs via the Activity Monitor)